Exploranium KT-9 - Page 76

68
S
TICK
— scan control from S
TICK
device
Figure 22
S
TICK
program showing a time-out after a free-space
measurement
k)
Place the sensor firmly at the beginning of the core or
profile to be scanned.
l)
Press and hold the trigger on the
S
TICK
to begin scan-
ning.
m)
If everything is
OK
, the KT-9 should be beeping with
the display showing:
Start moving the sensor along the core or profile. The
PC display will be showing each reading as it comes in:
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement
PRESS ’C’ ON PC TO CLEAR >> C
DISPLAY OF KT-9 MUST BE ’C 0’
PRESS ’R’ ON PC TO START SCAN MODE >>
End of 10 sec TIMEOUT
PRESS ’C’ ON PC TO CLEAR >>
5:000
68
S
TICK
— scan control from S
TICK
device
Figure 22
S
TICK
program showing a time-out after a free-space
measurement
k)
Place the sensor firmly at the beginning of the core or
profile to be scanned.
l)
Press and hold the trigger on the
S
TICK
to begin scan-
ning.
m)
If everything is
OK
, the KT-9 should be beeping with
the display showing:
Start moving the sensor along the core or profile. The
PC display will be showing each reading as it comes in:
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement
PRESS ’C’ ON PC TO CLEAR >> C
DISPLAY OF KT-9 MUST BE ’C 0’
PRESS ’R’ ON PC TO START SCAN MODE >>
End of 10 sec TIMEOUT
PRESS ’C’ ON PC TO CLEAR >>
5:000