Explore Scientific WSH4002 - Set the Clock Manually; Time Zone Setting

9
EN
IT
DE
FR
ES
5. RCC receiving will automatically start at 2:03, 3:03,
4:03, 5:03 every night. Auto receiving function will
cease if it is successful.
6. To stop RCC reception, press and hold the [ ]
button.
7. If the device is still not receiving the signal, please
proceed to set the time manually.
SET THE CLOCK MANUALLY
1. Press and hold [ ] button to enter into time and
date setting.
2. The setting parameter will flash.
3. Press [+] button once, the figure will increase 1
unit. Press and hold the [+] button, the figures will
increase rapidly.
4. Press [–] button once, the figure will decrease 1
unit. Press and hold the [–] button, the figures will
decrease rapidly.
5. Press [ ] button to confirm setting and enter to
next parameter.
6. Sequence of setting: Time zone  12/24h format
 Hour  Minute  Year  Calendar format (day-
month/month-day)  Month  Day  Temperature
unit (°C/°F)  Exit
7. If there is no action in 20 seconds or if you press and
hold [
] button, the setting will be saved and you
will exit the setting mode.
TIME ZONE SETTING
To set a different time zone, proceed as follows:
1. Press and hold [
] button to enter time setting.
2.The setting parameter will flash.
3. Press [+] button to increase or [–] button to decrease
the Time zone offset.
4. Press and hold [ ] button to confirm setting and
exit.
°C/°F SETTING
1. Press and hold [ ] button to enter time setting.
2. Press [ ]button several times until you reach
the Temperature unit setting.
3. Press [+] or [-] button to switch Celsius (°C) / Fahr-
enheit (°F).
4. Press and hold [ ] button to confirm setting and
exit.