Explore Scientific WSH4005 - Backlight Operation; Technical Specifications; Main Unit Specifications; Temperature and Humidity Ranges

BACKLIGHT
When operate with batteries, press [ SNZ / LIGHT ]
to activate backlight for 10 seconds to HIGH light.
When connect with adapter, plug in the adapter to
switch on the backlight to HIGH light. Press [ SNZ /
LIGHT ] to adjust the backlight brightness: HIGH
LOW OFF HIGH
SPECIFICATIONS
MAIN UNIT:
Dimensions
141 x 21 x 124 mm (L x W x H)
Weight
230 g (Exclude batteries)
Power:
DC 5V 150 mA adaptor
3x AAA (LR03) 1.5V batteries
TEMPERATURE:
Indoor temperature display range:
0°C to +50°C (32°F to 122°F)
Outdoor temperature display range:
-40°C to +70°C (-40°F to 158°F)
HUMIDITY:
Indoor/outdoor humidity range:
20% - 99% RH
OUTDOOR SENSOR:
Dimensions:
51 x 39,5 x 95 mm (L x W x H)
Weight:
45 g (Exclude batteries)
Transmission range:
30 m (98 ft)
Temperature range:
-40°C to +70°C (-40°F to 158°F)
Signal frequency:
433 MHz
Maximum transmission power:
under 10mW
Power:
2x AAA (LR03) 1.5V batteries
EC DECLARATION OF
CONFORMITY
Hereby, Explore Scientific GmbH declares
that theequipment type with part number:
WSH4005 is in compliance with Directive:
2014/53/EU. The full text of the EU declaration
of conformity is available at the following internet
address: www.bresser.de/download/WSH4005/
CE/WSH4005_CE.pdf
RCM DECLARATION OF
CONFORMITY
The product complies with electrical
safety, EMC and radio spectrum regulatory
requirements for products supplied to
the Australia or New Zealand market.
NOTES ON CLEANING
• Remove the batteries before cleaning.
• Only use a dry cloth to clean the exterior of the
device. To avoid damaging the electronics, do
not use any cleaning fluid.
• Protect the device from dust and moisture.
EN
IT
DE
FR
ES
NL
7