EU/UK Version 10 WTH600-E-en-GB_v1.0 4/18
2. Always place the unit away from interfering sources such as TV monitors, computers, etc.
3. Avoid placing the unit on or next to metal plates.
4. Enclosed areas such as airports, basements, or factories are not recommended.
Setting the Date and Time
The unit automatically sets itself accordingly to the Radio Controlled Clock signal it receives. To set
the clock/calendar manually, first disable the reception as explained in the One-Time and
Permanent Disable sections below and then continue with the steps in the next section.
Manually Setting the Clock and Time Zone
2. Use [UP] [DOWN] buttons to adjust, and press [CLOCK] button to continue.
3. Repeat step 2 above for TIME ZONE (North America version only), HOUR, MINUTE, SECOND,
YEAR, MONTH, DATE, and HOUR OFFSET.
Note:
1. If no buttons are pressed within 60 seconds, the unit will automatically exit this setting mode.
2. The HOUR OFFSET range is ± 23 hours. Adjust the offset accordingly to match the DCF/MSF
signal if necessary.
3. The time zone setting applies only to the North American version where the unit is set to receive
the WWVB signal. User can select PST, MST, CST, EST, AST or NST.
4. The language options are English (EN), French (FR), German (DE), Spanish (ES), and Italian (IT).
5. DST (Daylight Saving Time) feature defaults to AUTO. User can set the DST to OFF.
One-Time Disable / Enable RCC Signal Reception
1. Short press the [RCC] button to disable the reception temporarily.
2. Short press the [RCC] button to enable automatic RCC reception.
Permanent Disable / Enable RCC Signal Reception
1. Press and hold [RCC] button for 8 seconds to disable the reception permanently.
2. Press and hold [RCC] button for 8 seconds to enable automatic RCC reception.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
