CRNO CHRONO
This function allows the stove's ignition and switch-o to be automatically programmed.
The factory setting for CHRONO is o.
The chrono allows the programming of 4 time slots within a day, which can be used every day of the week.
Ignition and switch-o times can be set for each time slot, along with the specic days of application for the programmed time slot,
the desired temperature and power setting.
Current day and time settings are essential for the correct operation of the Chrono.
Recommendations
Before using the chrono function, you must set the current day and time, so check that you have followed the points listed in the sub-chapter
“DATE, DAY and TIME”. To use the chrono function correctly, you must activate it as well as program it. The four time slots can be overlapped
using the time switch on and o settings, This allows you to obtain a combination of times in which you can set dierent temperatures and
power without inuencing the stove work status.
NB: if overlapping time slots are set, the stove will stay on until the latest switch-o time.
PRG 14 PROGRAMMING 14
Prg x allows you to set the ignition time (STRT) and switch-o time (STOP), the days (DAY1= Monday / DAY7 = Sunday) included in the
programmed slot and the temperature (TEMP) (lou - 7° - 40° - hot), as well as the power (POW.) required. Current day and time settings are
essential for the correct operation of the Chrono.
CONTROLS PROCEDURE
Press and hold key 4.
Press key 3 until CRNO appears and access with key 4.
Select the slot using keys 2-3 and access it with 4.
Select one of the following options: STRT, STOP, DAY, TEMP and POW. and access with 4
Adjust using keys 4 and 5 and conrm with key 2.
Press key 1 several times to exit the menu.
ABIL ENABLE
Allows the chrono and the dierent stove time slots to be enabled/disabled.
CONTROLS PROCEDURE
Press and hold key 4.
Press key 3 until CRNO appears and access with key 4.
Press 4 to access ENABLE, 4-5 to select ON and OFF, and 2 to conrm.
Press key 1 several times to exit the menu.
STAT STATUS
References reserved for the technician
To Next Page
Loading...
Need help?
General
