Extreme Networks AP410C - Hardware Specifications; Radio and Connectivity Specifications

the button. To reboot the device, press the button for 5 seconds. To return the configuration to the factory default settings, press it forat least 10
seconds. After releasing the button, the indicator light goes dark, and then glows steady amber while the firmware loads and the system per-
forms a self-test. After the software finishes loading and the AP has connected to ExtremeCloudIQ, the status indicator glows steady white.
To prevent the reset button from resetting the configuration, enter this command:
no reset-button reset-config-enable
When this command is enabled, pressing the button for 5 seconds will still reboot the AP, but pressing it for more than 10 seconds will not reset its
configuration.
Security Slot
The AP410C has a security slot for locking the device.
Extreme Networks recommends a variety of Kensington
®
locks. For more information, contact your sales representative.
Hardware Specifications
The following sections list radio, device, power, and environmental specifications forthe AP410C.
Radio Specifications
l Radio 1: 5 GHx 2x2 band 1 and 2 + 2.4 GHz 2x2
l Radio 2: 2.4 Hz 1x1+ 5 GHz 1x1 (scanner)
l Radio 3: 5 GHz 4x4 full band or 5 GHz band 3 and 4
Operating Frequency:
l 2402 - 2483.5 MHz for the 2.4 GHz radio
l 5150-5850 MHz for the 5 GHz radio
Wi-Fi Channel Support
l WiFi 2.4G RX requirement: -96dBm@1Mbps
l WiFi 5G RX requirement: -93dBm@6M
Bluetooth BLE Beacon (BLE5.0)
l 2402 - 2480 MHz
l Frequency Hopping Spread-spectrum (FHSS) 802.11a
l 5150-5250, 5725-5850 MHz operating frequency
l Orthogonal Frequency Division Multiplexing (OFDM)
modulation
l Rates (Mbps): 54, 48, 36, 24, 12, 9, 6 with auto fallback
802.11b
l 2.4-2.48 GHz operating frequency
l Direct-Sequence Spread-Spectrum (DSSS) modulation
l Rates (Mbps): 11, 5.5, 2.1 with auto fallback
802.11g
l 2.4-2.48 GHz operating frequency
l Orthogonal Frequency Division Multiplexing (OFDM)
modulation
l Rates (Mbps): 54, 48, 36, 24, 12, 9, 6 with auto fallback
802.11n
l 5 GHz 5150-5250, 5725-5850 MHz operating frequency
l 802.11n modulation
l Rates: MCS0 - MCS7
l 2x2 MIMO radio
l HT20/HT40 support (HT40 is for 5 GHz only)
l A-MPDU and A-MSDU frame aggregation
AP410C Hardware Guide
7
AP410C Hardware Guide
7