Extreme Networks AP410C User Manual (English)

To Next Page

AP410C Hardware User Guide

Read about and view specifications and compliance information for the AP410C in this topic. Install the AP410C using this topic.

The AP410C is a high-performance 802.11ax dual-5G. dual band access point designed for indoor high-density environments. This device supports

IEEE 802.11ax Orthogonal Frequency-Division Multiple Access (OFDMA) multi-user access.

For regulatory and compliance information, see "Regulatory Compliance Statements".

Important! Change the Country Code

If youraccess point is configuredfor the WorldRegulatory Domain, it is important to set the country code to the country in which the APwill be

deployed to meet regulatory requirements and for optimal wireless operation. To do this, follow these steps:

The country code selection is for World models only and is not available to FCC, CAN, and other country-specific models. Per FCC reg-

ulations, all Wi-Fi products marketed in the United States must be set to U.S. channels only.

1. Power on the AP and allow it to find and connect to ExtremeCloudIQ. Once the APis connected it appears in the table of devices on the

Manage > Devices page.

Select the check box next to the AP, and then choose Assign Country Code from the Actions drop-down list. In the dialog box, select the

appropriate country from the drop-down list, and then click Save.

3. Uploadyour changes to the device.

Safety Guidelines

The safety information in this section applies to AP410C devices.

The following safety icons are used in these guidelines to identify the type of precaution:

AP410C Hardware Guide

Need help?

Do you have a question about the Extreme Networks AP410C and is the answer not in the manual?

Extreme Networks AP410C Specifications

General