Extreme Networks Extreme Wireless WSAP3825i - Installation; Unpacking the WS-AP3825; Accessories; Access Point Installation Procedures

3 Installation
Unpacking the WS-AP3825
Accessories
Access Point Installation Procedures
Configuring AP Channel Settings
Unpacking the WS-AP3825
To unpack the access point:
1 Open the box and remove the packing material protecting the AP.
2 Verify that the carton contains the items listed below.
Table 4: WS-AP3825 Package Contents
Quantity Item
1 WS-AP3825
2 Mounting brackets with screws
2 Wall mounting screws and plastic anchors
1 WS-AP3825 Quick Reference card
3 Perform a visual inspection of the AP for any signs of physical damage. Contact Extreme Networks if
there are any signs of damage. Refer to Getting Help on page 5 for details.
Accessories
The following accessories are available for the ExtremeWireless WS-AP3825. For ordering information,
contact your Extreme Networks sales representative.
•
12V DC power supply (see External Power Supplies on page 30)
•
External antennas (WS-AP3825e models only; See External Antennas on page 37)
Access Point Installation Procedures
Warning
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Electrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.
These procedures describe how to attach the WS-AP3825 to a drop ceiling (flat or protruded), and how
to mount the AP to a wall.
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version . 14