1 Attach the T-bar rail mount bracket to the back of the AP by placing the bracket against the AP
back, aligned as shown in Figure 5, with the bracket’s countersink screw holes matched up with the
screw holes on the AP. Screw the provided screws into the mounting bracket and AP as shown in
Figure 5.
Figure 5: Attaching a Mount Bracket to the AP back
2 Remove the ceiling panels around the drop ceiling T-bar rails where you intend to mount the AP.
Verify that the Ethernet cable that will connect to the AP can reach the AP at the point where you
plan to mount it.
Installation
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version . 16
To Next Page
Loading...
