Extron electronics DTP T UWP 4K 232 D - Page 26

Extron DTP T UWP 4K D Series • Remote Control 19
Command Function
SIS Command
(Host to Unit)
Response
(Unit to Host)
Additional Description
Reset
Reset to factory setting
E
ZXXX
}
Zpx
]
Reset to factory defaults
Information requests
Information request
I
In
X!
Vid • In
X!
Aud • Ausw
X@
• Vmt
X#
• Amt
X(]
View/Read EDID in HEX format
E
R
X!
EDID
} X1$]
Read data as text from the EDID assigned
and used on input
X!
View EDID native resolution
E
N
X!
EDID
} X1^]
Read out native resolution and refresh
rate from the EDID assigned to the
specified input in plain text.
Example: 1920x1200 @60Hz
Request part number
N
60-nnnn-nn
]
See www.extron.com, for part
numbers
Query firmware version
Q
x.xx
]
Query firmware version w/build
*Q
x.xx.xxxx
]
Verbose mode
NOTE: If tagged responses are enabled (modes 2 and 3), all “view” commands return the prefix and the value, just as the “set” commands do.
For example, the view auto switch mode (
E
AUSW
}
) command returns “Ausw
X@]
” in verbose mode 2/3.
Set verbose mode
EX1&
CV
}
Vrb
X1&]
Read verbose mode
E
CV
} X1&]
0 = clear/none
1 = verbose mode (default)
2 = tagged responses for queries
3 = verbose mode and tagged for queries
NOTES:
X! = Input number
X@ = Auto switch mode
X# = Video mute
X( = Status
X1$ = Raw EDID data
X1^ = Current EDID native resolution and refresh rate in plain text
1 through max number of outputs
0 = disabled/off/undetected (default)
1 = enabled/on/detected
2 = enabled (lowest active input has priority)
0 = disabled (default)
1 = enabled (highest active input has priority)
2 = enabled (lowest active input has priority)
0 = off, disabled, or not detected
1 = on, enabled, or detected
128 or 256 bytes of hexadecimal data