Extron electronics SM 3 - Removing the Speaker from the Mounting Plate

To Next Page

To Previous Page

Removing the Speaker from the Mounting Plate

To remove the speaker from the mounting plate, you must unlatch the locking mechanism:

1. Insert the security key into the keyhole of the speaker grill (see Step 2 of the previous

section) and turn the key to the unlock position.

2. Remove the security key.

3. Apply pressure with your finger over the keyhole to unlatch the speaker from the

mounting plate while lifting up on the speaker (see figure 9 below).

Press to Release

Figure 9. Removing the speaker from the mounting plate

ATTENTION: To avoid damaging or scratching the grill ﬁnish, do not use tools or sharp

instruments to depress the unlocking mechanism hidden behind the center

of the grill.

NOTE: The speaker may be supported by a safety line (see “Attaching a Seismic Support

Cable” in the following section).

SM 3 User Guide • Installation 10