Installation
The Installation section describes:
• Installing the Speaker Mounting Plate
• Attaching the Speaker to the Mounting Plate
• Removing the Speaker from the Mounting Plate
• Attaching a Seismic Support Cable
Installing the Speaker Mounting Plate
The SM 3 speaker comes with two types of speaker mounting plates:
• 0° mounting plate — The 0° plate allows the speaker to be mounted flat on a vertical
wall with the speaker protruding less than four inches (ADA compliant) from the wall
surface (see figure 2 below).
• 10° mounting plate — The 10° mounting plate allows the speaker to be installed at
a 10 degree angle so that the speaker can be pointed down from an elevated position
(see figure 2 below).
0° Mounting Plate 10° Mounting Plate
Figure 2. Two types of speaker mounting plates
SM 3 User Guide • Installation 3
To Next Page
Loading...