extronics iTAG XB BLE - Device MAC Address

13
0024
Button State Seconds
5? Second to 60 Seconds
R/W
uint16_t
Little Endian
Def: 30000
0025
Idle State - Packet Burst
Count
Number of packets sent if
the beacon timer is
> 1 second
R/W
uint8_t
Min 1
Max 5
0026
Connectable while in
motion, if set the
advertisement will be set as
connectable
R/W
Bool
1/0
0027
Connectable while Idle, if
set the advertisement will
be set as connectable
R/W
Bool
1/0
0030
BLE TX Gain, dBm, Valid
TX Gain settings are
-40dBm, -20dBm, -16dBm,
-12dBm, -8dBm, -4dBm,
0dBm and +4dBm
R/W
int8_t
Def: +4
0032
Interleaving time in
seconds while in Idle state
0 = No interleaving
250 Seconds Max
R/W
uint8_t
0033
Interleaving in Idle state,
Advertisement bit flags
R/W
uint8_t
(Bits)
*00FF
Enabled
1 - Beaconing is active
0 - Sleeping/shipping - No
beaconing
R/W
uint8_t
Def: 0
*If enabled is unchecked then device will go into storage state on below,
• After writing configuration file to device
• After reboot/power cycled
Device MAC address
Extronics tags by default use the Random Static Address. Random static number used is
provided by Nordic ID (the supplier of the BLE SoC IC). It is a 46bit random number
generated by the IC supplier at the point of manufacture. Random Static addresses is
detailed in Bluetooth core specification Version 5.1 Vol 3 Part c section 10.8 page 1390 & in
Bluetooth core specification Version 5.1 Vol 6 Part B section 1.3 page 2860.