Eye Vac EYEVAC+ - Cleaning the Exhaust Filter Holder; Cleaning the Canister; Storage

7
CLEANING THE EXHAUST FILTER HOLDER
CLEANING THE CANISTER
STORAGE
1. To clean the Exhaust Filter Holder, press the Vacuum Power button to the off position, press the trash bin
lid Power button to the off position, and unplug the unit.
2. The Exhaust Filter Holder slides up and out of its housing on the side of the unit.
3. Gently pull the Filter out of the Filter Holder.
4. Tap Filter gently against trash container to free and eliminate excess dirt and debris.
5. To clean the Filter, wash in mild soap and water; rinse and dry thoroughly before assembly
6. Slide the Holder back into the unit with the Filter facing outwards.
IMPORTANT! NEVER OPERATE EYEVAC+ WITHOUT THE EXHAUST FILTER & FILTER HOLDER PROPERLY IN
PLACE.
The Canister should be washed periodically.
1. To clean the EyeVac+ Canister, press the Vacuum Power button to the off position, press the trash bin lid
Power button to the off position, and unplug the unit.
2. Wash the Bin in warm water using a mild soap. Avoid harsh or abrasive cleaners or sponges. Rinse
thoroughly.
TO AVOID DAMAGE, DO NOT PLACE CANISTER IN THE DISHWASHER.
3. Let it air dry. Make sure the Canister is completely dry before putting it back into the EyeVac+.
4. Insert the assembled Canister following the instructions outlined in the USER MAINTENANCE
INSTRUCTIONS.
IMPORTANT! Other than cleaning the Pre-Motor Filter and replacing the Exhaust Filter Holder, as
described in this Owner Manual, this EyeVac+ is not user serviceable. There are no user serviceable
parts inside the unit. Servicing by our Authorized Service Center is required to avoid damage to internal
components.
1. To store the EyeVac+ press the Vacuum Power button to the off position, press the trash bin lid Power
button to the off position, and unplug the unit.
2. Store EyeVac+ indoors, in a clean, dry place.
3. Never store EyeVac+ while it is still plugged in. Never wrap cord tightly around the appliance, use the
Cord Storage area on the back of the EyeVac+ unit. Do not put any stress on the cord where it enters the
unit, as it could cause the cord to break.
WARNING! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT USE OUTDOORS OR ON WET SURFACES.
EyeVac Plus.indd 7EyeVac Plus.indd 7 4/1/21 2:57 PM4/1/21 2:57 PM