What to do if indicator lights are red on EZ TANKLESS 202 Water Heater?
If your EZ TANKLESS Water Heater has indicator lights that are red, this suggests a power shortage. To solve this, replace the batteries.
Why is the water temperature low on my EZ TANKLESS 202 Water Heater?
If you experience low water temperature even when the EZ TANKLESS Water Heater is set to 'high', check for an inadequate water supply. Clean the filter, and then have a professional check the water pressure. Also, ensure that the water temperature control is set correctly. Finally, ensure that there is sufficient fresh air.
What causes a bumpy noise in ignition of EZ TANKLESS 202 Water Heater?
If your EZ TANKLESS Water Heater makes a bumpy noise during ignition, it could be due to a clogged burner, a clogged heat exchanger, a failure of the water control unit, or ignition needle movement. In any of these cases, contact the service center.
Why does the flame go out on my EZ TANKLESS 202?
If the flame goes out on your EZ TANKLESS Water Heater, it could be due to several reasons. First, ensure the gas valve is fully open; turn on the main valve or replace the gas supply. If the gas valve is only half open, fully open the main valve. Air in the gas pipe can also cause this; run water until the air clears from the gas system, repeating every 20 seconds until ignition. Unsuitable gas pressure may be the issue, in which case you should contact a repairer to check the gas pressure valve. Verify that the cold water valve is open by turning on the water supply main valve. Finally, freezing conditions can cause the flame to go out; use the heater after defrosting.
What to do if EZ TANKLESS Water Heater runs continuously for 20 minutes?
If your EZ TANKLESS Water Heater operates continuously for 20 minutes, re-ignite it by turning the water valve off and then back on.
Specifies room ventilation, area, exhaust/ventilation hole placement, and window height.
Covers drilling, mounting, piping, and flue duct installation steps.
Ensure correct gas type, valve operation, and checks for water flow.
Procedure for draining the water heater in cold weather to prevent freezing.
Recommendations for leak detection, checking connections, and handling gas leaks.
Precautions against fire, including extinguishing flames and avoiding flammable items.
Explains CO production and emphasizes ventilation and flue duct installation.
Advises keeping distance from flame indicator and handling freezing.
Actions for high winds, abnormal burning, or other issues.
Warnings about hot water temperature after repeated use or high settings.
Explains normal behaviors like ignition issues at low pressure or timer shut-off.
Checks gas lines, water filters, leaks, and flame condition.
Recommends periodic professional servicing and keeping the heater clean.
Provides a table of symptoms, reasons, and remedies for common issues.
Addresses power shortage, clogged parts, and operational limits.
General| Flow Rate | 6.0 GPM |
|---|---|
| Temperature Range | 86-167 °F |
| Dimensions | 15 x 5 x 20 inches |
| Weight | 22 lbs |
| Type | Tankless |
| Power Supply | AC |
To Next Page
