On the device details screen you can see the device status
Include
Pending - Please check if your device is powered on and
placed near this controller or another Z-Wave powered
device
Failed - Please remove the device from your system and try
again. After you scan the QR code, make sure when you
power ON the device, it is placed near this controller or
another Z-Wave powered device
Other system device - To add the device to this controller
you have to rst delete the SmartStart entry and remove
the device from the current controller. After that, you have
to add the device to this controller
Add manually - When Z-Wave classic connection type is
used you need to add the device manually.
To Next Page
Loading...