Need help?Do you have a question about the eZLO Plus and is the answer not in the manual?
General| Brand | eZLO |
|---|---|
| Model | Plus |
| Category | Controller |
| Language | English |
Install the Vera app from the iOS App Store or Google Play.
Log in if you have an account, or tap 'New to Vera' to create one.
Choose between wired or wireless setup for your Ezlo Plus hub.
Control your home from anywhere using the Vera app.
Access the wizard by tapping the '+' icon in the Devices menu on the dashboard.
Choose or search for the specific device type you wish to pair with your Ezlo Plus.
Automatically add Z-Wave devices by scanning their QR codes via SmartStart.
Use your phone's camera to scan the SmartStart QR code found on the device box.
Add SmartStart devices by manually entering the DSK code if QR scan fails.
Input the 40 digits of the DSK code from the device box to continue.
Add devices using SmartStart flow by selecting the Z-Wave SmartStart entry.
From the device list, tap the device and go to its settings.
Choose 'Unpair' if device is connected, 'Delete' if it's no longer present.
Go to Settings and tap 'Learning Mode' to begin connecting to another controller.
Tap 'Enable Learning mode' to add this hub as a secondary hub.
Find the 5-digit DSK code on the Ezlo Plus bottom or package box.
Go to Devices menu and tap the '+' icon to add a new controller.
Tap 'Ready to include' to start a 60-second countdown for controller inclusion.
Manually enter the first five digits of the DSK code if QR scanning fails.
Go to Devices, select the controller to remove.
Confirm deletion and disable learning mode on the secondary controller within 60 seconds.
Push and hold the RESET button for 5 sec to reset the controller to factory defaults.
In Devices, go to Z-Wave settings and select 'Rediscover device'.
To Next Page