EZM FG-100 User Manual

1. Press the power switch (POWER) button to turn on the power, then the power
LED and LCD backlight lit simultaneously.
2. After boot, LCD cursor position in a hundred K frequency flicker.
Then you can use the +, - keys to adjust the value, which is to adjust the frequency.
Each press of the cursor (CURSOR) button, the cursor moves to the right one. Bit
value blinking cursor can be used +, - keys to adjust the value. When the value of
the desired frequency adjustment is completed, press the operation is stopped
(RUN / STOP) button, the cursor disappears, it will generate a waveform output. To
obtain the desired waveform, you can press the "RUN / STOP" key, then the cursor
appears, click on each mode (MODE) button will change one of these waveforms.
After the waveform information to be displayed, press the "RUN / STOP" button, it
will output the desired waveform.

EZM FG-100 Specifications

General

Brand	EZM
Model	FG-100
Category	Inverter
Language	English

Summary

Function Generator Operation Guide

Powering On and Initial Setup

Instructions for turning on the power switch and observing the power LED and LCD backlight.

Frequency Adjustment and Waveform Output

Details on using cursor and +/- keys for frequency adjustment and generating waveforms via RUN/STOP.

Waveform Mode Selection

How to change waveform types by pressing the MODE button after activating waveform output.

Advanced Function Controls

Filter Button Usage

Using the FILTER button to smooth sine waves and filter other waveforms, noting impact on square waves.

DC Offset Functionality

Explanation of DC OFFSET use for waveform symmetry and adjustment via potentiometer.