4
Figure :Connect the Wires
Step 6
Snap the wire connector into place.
After securing the wires, snap the wire connector into the base of the mounting bracket.
UP
Mounting Bracket
Wire Connector
Step 7
Place security light camera on the bracket.
Step 8
Restore power at the breaker.
Align the mounting posts with the holes on security light camera
and press together, securing the base screw caps.
Turn on power to your security light’s circuit.
Base Screw Cap
Wires from your wall Connect to Matching Wire on Camera
Yellow-green-Ground Yellow-green
Brown-Hot Brown
Blue-Neutral Blue
To Next Page
Loading...
