3
• Don’t use the device in an environment higher than 40°C or lower than
0°C.
• Don’t use the device to clean any flammable materials (such as gasoline,
toner). Don’t use the device in the area with flammable materials.
• Don’t use the device to clean burning items, such as matches, cigarettes
and other items that may cause re.
• Don’t use the product to absorb large stones, waste paper and other
items that may block the product. When the suction port is blocked,
please clean the product in time and remove the dust, cotton, hair, etc.
at the suction port.
• Use only the accessories recommended or sold by the manufacturer.
Don’t use the batteries or docking station of any third party, and don’t
use damaged batteries or docking station.
• Dispose of used batteries in accordance with local laws and regulations.
• Don’t burn the device under any circumstances, as the battery may
cause explosion.
• After the RGB camera is contaminated with dust during use, it is
recommended to use the air blower to clean the camera, or use a paper
towel and soft dry cloth to wipe and clean, don’t use rough or hard
materials, so as to avoid scratches on the glass surface of the vision
module.
• If the rear surface of the robot is too dusty, it will affect the recharging of
the robot. It is recommended to clean it regularly or as needed. It is also
recommended to use a paper towel or soft dry cloth to clean it.
• If the surface of the edge sensor on the side of the robot is contaminated
with lots of dust, it will affect the posture and mapping positioning effect
of the robot when walking along the wall. It is recommended to clean it
regularly or as needed. Since the sensor is located inside the body, it is
recommended to use the air blowing tool/ paper towel/soft dry cloth for
cleaning the camera to wipe the sensor. Don’t put your ngers into it for
cleaning.
• The bottom of the robot is easy to be contaminated with lots of dust, so
it is recommended to clean it regularly or as needed.
• Please use the device according to the instructions in the manual. Any
To Next Page
Loading...
