EasyManua.ls Logo

F40C4TMP FLOW35 - Advanced Troubleshooting; Understanding Surface Condensation; Error Code Resolution

F40C4TMP FLOW35
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
▲ Condensation of the Refrigerator Surface
When the ambient air humidity is >75%, a slight frost will occur on the surface of the cabinet, which is
a normal phenomenon.
Note: For the replacement parts, please contact F40C4TMP customer service team.
ErrorCode
E1
E2
E3
Error Type
The input voltage is too low
Fan problem
Compressor starts frequentlyor
input voltage failure
Solutions
① Condition: Plug the 12V DC cord into the car cigar
lighter before the car engine starts.
Solution: Plug the DC cord intothe car cigarlighterafter
the car engine starts.
② Condition: The input voltage of the adapter is too low.
Solution: Adjust the battery protection modeto
Middle/Lowlevel. If the fridge still does not work
normally,pleaseuse a new adapter.
Solution: Please replace with a new fan.
① Condition: E3appears when using the DC cord.
Solution: Please use the AC adapter to test it. If the
refrigerator can work normally without the E3 code, you
need to check your external power supply.
② Condition:E3 appears when using the AC adapter.
Solution: Please power off the refrigerator for 5 minutes.
After that,turn on the refrigerator. If E3 still appears,
please replace the compressor controller.
Solution: Please power off the refrigerator for 1 hour,
and then restart it to see if E4 still appears. If it is, please
replace the compressor controller.
Solution: Power off the refrigerator for 15 minutes. Then
turn it on to check whether the fan rotates. If it doesn't,
please replace the fan.
Note: Reserve 15cm for the cooling holes for ventilation.
Solution: Disassemble the control panel to check
whether the NTC cord is loose.
Note: The NTC cord is inside the control panel.
E4
E5
E6
Compressor turbine speeds is
too slow
Controller chip overheated
NTC open circuit or short circuit
TROUBLES AND TROUBLESHOOTING
3
_ _

Related product manuals