EasyManua.ls Logo

FAAC T-MODE TM R Series - Declaration of Conformity; Warnings for the Installer

FAAC T-MODE TM R Series
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
2
WARNINGS FOR THE INSTALLER
DECLARATION OF CONFORMITY
Manufacturer: FAAC S.p.A.
Address: Via Calari, 10 - 40069 Zola Predosa BOLOGNA - ITALY
Declares that: Operator mod. TM 45 radio - 433Mhz
• conformstotheessentialrequirementsofthefollowingEECdirectives:
-2006/95/EEC
- 2004/108/EEC
-99/05/EEC
•itthusconformstothefollowingharmonisedstandards:
-EN60335-1-95,EN60335-2-97/10-2000.
-EN61000-3-2,EN61000-3-3,
-EN55014-1,EN55014-2
Bologna,01/12/2012 TheManagingDirector
A. Marcellan
1. ATTENTION! To ensure the safety of people, it is important that
you read all the following instructions. Incorrect installation or
incorrect use of the product could cause serious harm to people.
Keep these instructions for future reference.
2. Carefully read the instructions before beginning toinstallthe
product.
3. This product was designed and manufactured exclusively for
thepurposeindicatedinthisdocumentation.Anyotheruse,not
expresslyindicatedhere,couldcompromisethegoodcondition/
operationoftheproductand/orbeasourceofdanger.
4. FAACdeclinesanyresponsibilityforimproperuseoruseotherthan
thatforwhichtheautomatedsystemwasintended.
5. Disconnect the power supply before any operation on the
system.
6. Theinstallationmustbecarriedoutbyqualifiedtechnicalpersonnel
inconformitywiththenormsinforce.
7. Thepowermainsoftheautomatedsystemmustbefittedwitha
multi-polepowerswitchwithaswitch-contactgapofatleast3
mm.
8. Themin.installationheightfortheautomatedsystemis2.5m.
9. Makesurethatadifferentialswitchwithtripthresholdof0.03A
isfittedupstreamofthesystem.
10.
11. UseonlyFAACoriginalpartsformaintenance.
12. Theequipmenthandlingmustalwaysbeatsight.
13. Donotallowchildrenoradultstostayneartheproductwhile
itisoperating.
14. Keepradiocontrolsorotherpulsegeneratorsoutofreachof
children,topreventtheautomatedsystemfrombeingactivated
unintentionally.
15. The automated system cannot be repaired/adjusted by the
end-user;theseoperationscanonlybecarriedoutbyqualified
personnel.
16. Anything not expressly specified in these instructions is not
permitted.
17. The setting of the travel stops must be made with the motor installed
inside the tube (not at the bench).
18. Theequipmentisnotintendedtobeusedbypeople(childrenincluded)
withoutsufficientexperienceorknowledge,unlesstheyaresurveilledor
instructedontheequipmentusebyapersonresponsibleforthesafety.
19. Children must be supervised to make sure they do not play with the
equipment.
20. IncaseofoutdoorinstallationinstallthedesignatedcableH05RR-Fwitha
min.carbonpercentageof2%andamin.sectionof4x0.75mm².
21. Intheversionwithradiocontroltheinstallationofthestepbuttonforthe
manualoperationincaseofradiocontrolproblemsismandatory.

Related product manuals