FAAC TM2 PP M - Key to Symbols; Command Sequences Example; Instruction for Use

To Next Page

To Previous Page

TM2 PP M 12 A4516_6G38_Rev.A

KEY TO SYMBOLS

UP DOWN

Press the

UP-button

Press the buttons quickly according to the sequence indicated.

Press the

DOWN-button

DOWN DOWNUP

DOWN

COMAND SEQUENCES EXAMPLE

UPUP UP

Most of the command sequences have three or six distinct steps.

The buttons must be pressed for less than 0.5 seconds as shown in the sequence,

without taking more than 1 second between one step and the next. If more than 1

second is taken, the command is not accepted and the sequence must be repeated.

Command sequence example:

Attention! If the sequence requires a repetition

of the same commands (Up+Up/ Down+Down),

an interposition of the Stop position could be

necessary depending on the type of switch in use.

INSTRUCTION FOR USE

The tubular motor is very simple to be used and installed, it does not need any

regulation as it automatically detects the position of limit switch.

The rolling shutter must be equipped with:

A - security locks or stiff fixing springs,

B - fixed or removable stoppers for end slats.

It is very important to check the sturdiness of the

rolling shutter.

Execute a complete cycle of opening and closing

before using the manual override device.

Note: After manual override, the motor resets the proper positions upon reaching

a valid limit switch position.