FAAC XR4 433 C - Product Description and Configurations; Technical Specifications

1
0
70
32,5
90
105
98
CH1 CH2 CH3 CH4
5
DL1
DL2 DL3 DL4
SW1
SW2 SW3 SW4
SW5
DS1
DL6
12
6
7
8
14
9
10
11
12
13
1
2
3
4
N.O. N.O. N.O. N.O.
DL5
+
ENGLISH
2 TECHNICAL SPECIFICATIONS
XR4 433 C - XR4 868 C
XR4 433 C XR 868 C
POWER SUPPLY (V) 12 ÷ 24 ac-dc 12 ÷ 24 ac-dc
RECEPTION FREQUENCY (MHz) 433.92 ±0.1 868.35±0.2
ABSORBED CURRENT (mA) 100 mA 100 mA
DECODING (OMNIDEC SYSTEM) DS-LC-SLH DS-SLH
SAVEABLE CODES 250 CH1-2 / 250 CH 3-4 250 CH1-2 / 250 CH 3-4
NUMBER OF CHANNELS 44
NUMBER OF RELAY OUTPUTS (N.O.)
N 2 pulsed (CH 1-3)
N 1 pulsed/fixed (selectable) (CH2)
N 1 timed (CH4)
N 2 pulsed (CH 1-3)
N 1 pulsed/fixed (selectable) (CH2)
N 1 timed (CH4)
RELAY CONTACTS CAPACITY 0.5 A / 120 VA 0.5 A / 120 VA
PROTECTION CLASS IP 44 IP 44
OPERATING AMBIENT TEMPERATURE (°C) -20 / +55 -20 / +55
/Preperforated facility for cable grippers (16.5 diam)
0Cover
1Facility for securing on DIN guide
2Fittings for screw securing
3 Terminals for command output (N.O.)
4 Normally open (N.O.) relay contact
5 Signalling LEDs ( ON= OUTPUT ACTIVE )
DL1=LED CH 1 DL2=LED CH2
DL3=LED CH3 DL4=LED CH4
6 Radio programming push-buttons
SW1=PUSH-BUTTON CH1 SW2= PUSH-BUTTON CH2
SW3=
PUSH-BUTTON CH3 SW4= PUSH-BUTTON CH4
7
DL6: LED signalling time programming CH4
8 SW5: Time programming push-button CH4
9Selection dip-switch
: Power supply terminal
; Terminal for antenna
< DL5: Mains ON LED ( ON=MAINS PRESENT )
1 DESCRIPTION
The XR C control board is a four-channel external receiver, which has an integrated decoding system (DS, SLH, LC),
named OMNIDEC. When a channel is activated by radio control (DS, SLH, LC), the relevant N.O relay contact closes
by the methods described in chapter 5.
The selectable configurations are :
CH1= pulsed N.O. relay output CH2= pulsed/fixed N.O relay output (selectable by DS1)
CH3= pulsed N.O. relay output CH4= timed N.O. relay output (can be adjusted with SW5)
Fig.1
SLOW FLASHING
DL6
30 SECS. TIME BASE
SELECTED AND OUTPUT ACTIVE
FAST FLASHING
DL6
1 SEC. TIME BASE
SELECTED AND OUTPUT ACTIVE
DS1 ON OFF
DIP-
SWITCH 1
CHANNEL 2 FIXED
OUTPUT
CHANNEL 2 PULSED
OUTPUT
DIP -
SWITCH 2
CHANNEL 4 TIME BASE
1 SECOND SELECTION
(SEE CHAP. 6)
CHANNEL 4 TIME BASE
30 SECONDS SELECTION
(SEE CHAP.6)