5
Adjust the Top Limit
Adjust the Bottom Limit
1. Press & hold (UP+STOP) for five seconds, the motor will jog once and beep once.
2. Go to new desired top position. Motor will be in Jog Mode.
3. Press & hold (UP+STOP) for two seconds, the motor will jog twice and beep three times to
signal that the new top limit is set.
1. Press & hold (DOWN+STOP) for five seconds, the motor will jog once and beep once.
2. Go to new desired bottom position. Motor will be in Jog Mode.
3. Press & hold (DOWN+STOP) for two seconds, the motor will jog twice and beep three times to
signal that the new bottom limit is set.
Operate Shade Manually
1. Short press the PROGRAM button on the MOTOR. Motor will go up, stop, or go down. Top &
bottom limits must be set for this function.
Add Additional Remotes
1. Press the PROGRAM button on the already paired REMOTE twice. The motor will jog once
each time you press the button.
2. Press the PROGRAM button once on the new REMOTE. The MOTOR will beep 3 times and jog
to confirm addition of the remote.
Mute the Motor
Press & hold the PROGRAM button on the MOTOR for 2 jogs (approximately 6 seconds).
Release immediately after the 2nd jog. The motor will beep 2 times to confirm.
Pressing the PROGRAM button on themuter MOTOR once will restore it to normal operation.
This will “mute” the motor when you do not want it to respond to commands from the remote to which
it is paired. This is used most often when programming multiple motors to the same remote.
Reset to Factory Defaults
To delete all programming and reset your motor to factory defaults, press & hold the
PROGRAM button on the MOTOR, releasing after the 4th jog (12-14 seconds). The motor will beep/
jog 4 times confirming the factory reset.
To Next Page
Loading...