Facom E.316 Series - User Manual

To Next Page

INSTRUCTIONS

E.306 & E.316

Introduction

To start the communication between your electronic torque wrench and a computer you need to :

- install on your computer the USB driver which is used to connect the torque wrench with the PC,

- install the UPLOADER program needed to store on the PC the values measured with the torque wrench.

This manual contains the following sections:

1. USB driver installation

2. UPLOADER program installation

3. Upload torque wrench records to PC

1 - USB driver installation

- Insert the installation CD into CD-ROM or open the folder uploaded from the FACOM.COM internet page

- In the «USB driver» directory run the «CP210x_VCP_Win2K_XP_S2K3» application

- Follow the instructions during installation

Once the installation is complete, an icon on the right side of your screen shows the PORT COM number to use for

further communication.

Need help?

Do you have a question about the Facom E.316 Series and is the answer not in the manual?

Summary

Run the UPLOADER program from the start menu to begin data transfer.

Connect the USB communication cable between the PC and the torque wrench.

Select the correct COM port, path, and press Upload to transmit records.

General