fadini Elpro 37 - Traffic Lights Plug-In Card; Functioning with 2 Lamps

page 13
Traffic lights plug-in card (optional - Item No. 7282L):
The power supply of this card is independent from that of the control board:
230V 50Hz with an output of 100W at 230V each lamp.
Logic of operation:
- GREEN light = driveway OPEN
- RED light = driveway CLOSED
- YELLOW light = it switches on before light changes from green to red
Note: In pedestrians mode the traffic light is always RED.
RED
YELLOW
GREEN
Power supply 230V 50Hz
Red
Yellow
Green
Red
Yellow
Green
Fuse 1A
Common
63 64 65 66 60 61
(Optional: Traffic lights
plug-in card for
230V Lamps)
Item 7282L
Dip-switch A
4= ON Pre-flashing enabled: traffic lights red - yellow - green
4= OFF Pre-flashing disabled: traffic lights red - green
Functioning with 2 lamps (red and green):
Dip-switch A 4 = OFF
Power connections
to Pulin 3 LEDs:
Terminals for the
connections
of the LEDs of the
push buttons
Pulin 3
28 2627
OUTPUT
24Vdc - 5W max
3
24Vdc-5W
output:
36 37
+ -
meccanica
FADINI
37
Accessory
Electrical connections
SINGLE – THREE PHASE ELECTRONIC CONTROL BOARD WITH ELECTRONIC BRAKE
FOR SLIDING GATE AUTOMATIC SYSTEMS WITH OR WITHOUT LIMIT SWITCHES
GB