Need help?Do you have a question about the Fagor Innova 10i and is the answer not in the manual?
Details the LEDs and keys on the DRO's front interface.
Covers the procedures for powering the DRO unit on and off.
Explains various display modes like MM/INCH, radius/diameter.
Details the sequence for referencing the machine axes.
Describes how to input and manage tool length values.
Explains operating in absolute and incremental modes with examples.
Explains how to apply a scaling factor for mold making.
Describes the procedure for part centering using the DRO.
Provides dimensions and procedures for installing the built-in DRO.
Explains how to connect feedback systems (encoders) to the DRO.
Details how to enter the Easy Setup mode for configuration.
Describes the steps for operating mode setup in Easy Setup.
Configures feedback type, units, and counting direction.
Sets feedback resolution for linear and rotary axes.
Refers to UL seal information on page 12.
Details the CE seal and declaration of conformity.
General| Display | 10.4" TFT LCD |
|---|---|
| Processor | Intel Atom |
| Power Supply | 24 VDC |
| PLC | Integrated |
| Operating System | Windows Embedded |
| Connectivity | Ethernet, USB |
| Protection Rating | IP65 |
To Next Page
