Need help?Do you have a question about the Fagor Innova 30i-M and is the answer not in the manual?
Describes the LED's and keys on the front panel of the DRO.
Explains coordinate systems (Incremental, Absolute, Home) and mode switching.
Explains how to set a machine zero point using reference marks and home search.
Covers defining and compensating for tool dimensions during machining.
Describes the process for inputting tool dimensions into the DRO.
Explains how to apply tool diameter compensation during machining.
Details setting the part zero for tool compensation operations.
Details how to perform linear and bolt-hole drilling operations.
Provides dimensions and instructions for installing the built-in DRO.
Guides through the initial setup and configuration of the DRO.
Describes the procedure to enter the DRO's Easy Setup mode.
Covers proper power and machine connections for the DRO.
Details parameters for axis reading and display configuration.
Covers feedback device type, resolution, and counting direction.
Outlines essential safety measures for operating and handling the DRO.
General| Resolution | 800 x 600 pixels |
|---|---|
| Connectivity | Ethernet, USB |
| Power Supply | 24 VDC |
| Display | 10.4" TFT LCD |
| Protection Rating | IP65 |
To Next Page
