•
The oven must be set on a work surface at least 85 cm above floor level.
•
Place the oven on a flat and horizontal surface, away from any source of heat
or steam. *For certain models, to ensure the stability of the microwave oven,
the front left foot is adjustable (5 positions). Turn it to raise or lower the
appliance.
•
Make sure that air may circulate freely around the oven.
11
Location
INSTALLATION
Electrical connection
GB
*
Before connection
For countertop models, leave sufficient
space around the oven :
- 5 cm between the sides of the oven
and any walls or objects
- 20 cm above the oven
- 10 cm behind the oven.
•
Allow nothing to obstruct the ventilation
louvers at the back of the appliance.
•
Make sure the electrical plug will be accessible after installation.
•
Check whether your oven has suffered any damage during transport (deformed door or
door seal, etc.). If you see any signs of damage, contact your dealer before use.
•
Verify the power voltage. If there is a PERMANENT undervoltage (200-210 volts), consult your
electrical installer.
•
Your installation must be protected by a 16 Amp thermal fuse.
•
It is mandatory to use a power point with a ground terminal, connected in accordance with
current safety regulations.
•
In your electrical installation, provide a device that is accessible to the installer, capable of
separating the appliance from the mains power and whose contact opening is at least 3 mm
at all of the poles.
•
Never operate the oven if the supply cord and/ or its plug are damaged. In case of damage,
call in a specialised technician trained by the manufacturer.
To Next Page
Loading...
