EasyManua.ls Logo

Fahrenheit JET-503 - User Manual

Fahrenheit JET-503
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
User ManUal
anwendUngsinforMation
Használati Utasítás
ManUal de Utilizare
UpUtstvo za UpotrebU
Užívateľská prírUčka
PENCIL TORCH
BLEISTIFTFACKEL
GÁZFORRASZTÓ CERUZA
CREION DE LIPIT CU GAZ BUTAN
GASNA LEMILICA
SPÁJKOVAČKA PLYNOVÁ
Product code / Termékkód / Cod produs / Šifra proizvoda / Kód produkta: 28098

Table of Contents

Questions and Answers

  • K
    Karen MunozAug 10, 2025
    Why is my Fahrenheit Welding Accessory unable to ignite?
    • B
      Brian Matthews Jr.Aug 10, 2025
      Your Fahrenheit Welding Accessory might not ignite due to a couple of reasons. First, check if it has fuel; if not, refill it with Butane gas. Secondly, the gas pressure might be too high or too low. Try sliding the regulator to a lower or higher position to adjust the pressure.
  • D
    Diane BeltranAug 26, 2025
    What to do if gas is overflowing from my Fahrenheit Welding Accessories?
    • J
      Jordan GarciaAug 26, 2025
      If gas is overflowing from your Fahrenheit Welding Accessories, it's likely the setting is too high. Adjust the flame regulator gradually and try to ignite it again.

Fahrenheit JET-503 Specifications

General IconGeneral
ModelJET-503
CategoryWelding Accessories
TypePlasma Cutter
Frequency50/60 Hz
Cutting Thickness12mm
Duty Cycle60%