EN
User Manual
warning!
• Flame is invisible in the sun; it bevomes harmful when carelessly used.
• The top turns scalding hot in use. Do not touch or push.
• Ensure that the ame is out when putting down the Pencil Torch
• Keep away from ammable materials.
• Do not place or rell the torch near ame, heater or ammable materials.
• Do not place it in the sun or a place where the temperature exceeds 25°C
• Do not keep it in the car on a hot day.
• Use in a well-ventilated place.
• Do not soak it in water.
• Keep away from children
operating instrUctions
Your JET-503 Pencil Torch is simple to use.
• Slide the switch to On or O.
• Press ball at the end to ignite. The torch ignites automatically, thanks to its hi-tech, state-of-the-art
Piezo electronic ignition system.
• Slide regulator to adjust ame height.
• Draw out the inner-loaded support if necessary
• Ensure that the switch is o while relling. Press container nozzle down vertically into rell
opening. Gas will overow when full. After lling, allow a few minutes for gas to stabilize before
using.
troUblesHooting
Problem Probable cause Solution
Unable to ignite
1. No fuel
2. Gas pressure too high or
low
1. Rell with Butane gas
2. Slide regulator to a lower or
higher position
Gas overowing Setting too high
Adjust ame regulator gradually and
ignite again
Low gas pressure Fuel is cold
1. Refuel
2. Hold torch in hands to warm it up
To Next Page
Loading...