Fairland Pioneer PHC80LS

Questions and Answers

C
Christopher NelsonAug 7, 2025
What to do if my Fairland Pioneer Heat Pump automatic start/stop is not working correctly?
- Q
  qholderAug 7, 2025
  If the automatic start/stop function of your Fairland Pioneer Heat Pump isn't working, check the following: Ensure the manual on/off switch is set to 'on'. Also, check if the circuit breaker has tripped or the fuse has blown. The machine might be in a delayed start phase (the 'on' LED is lit up), or the timer might be on (the ‘On’ indicator light is lit up).
J
John StoneAug 12, 2025
Why is my Fairland Pioneer PHC80LS making a clicking/popping sound?
- A
  Angela TranAug 12, 2025
  The clicking/popping sound in your Fairland Pioneer Heat Pump is likely due to the noise made by the 4-way valve during cycle inversions for heating/defrosting or defrosting/heating.
E
Emily MclaughlinAug 16, 2025
Why is my Fairland Pioneer PHC80LS making a clicking/popping noise?
- T
  Thomas MartinezAug 17, 2025
  The clicking/popping noises in your Fairland Pioneer Heat Pump may be caused by the heat exchanger as it expands and contracts due to temperature variations.
O
oneillmichelleAug 22, 2025
What to do if my Fairland Pioneer PHC80LS does not start up?
- C
  Corey HowardAug 22, 2025
  If your Fairland Pioneer Heat Pump doesn't start, verify that the water temperature at the heat pump outlet is a few degrees warmer than the water temperature at the inlet. Also, ensure that the air inlet and exhaust are not obstructed.
J
Jonathan AndersonAug 27, 2025
Why is my Fairland Pioneer PHC80LS making a flowing sound?
- L
  Lori HicksAug 27, 2025
  The flowing sound in your Fairland Pioneer Heat Pump is likely due to the circulation of heat exchange fluid or drainage of condensates. This can occur while the heat pump is running, just after it stops, and during the first 2/3 minutes after the machine starts up.
A
Aaron StewartSep 1, 2025
Why is steam escaping from my Fairland Pioneer PHC80LS Heat Pump?
- N
  Nicholas LoganSep 1, 2025
  The steam escaping from your Fairland Pioneer Heat Pump is because the fan stops automatically for defrosting.