Fakir VERONICA - Maintenance and Cleaning; Troubleshooting

21
EN
Maintenance and Cleaning
Before cleaning the steam iron, the plug must be unplugged and it must fully cooled. Do
not use corrosive cleaning agents.
Never submerse the iron in water or other liquids.
Fill the water tank with normal tap water, rinse and empty.
Clean the iron base with a damp piece of cloth.
Troubleshooting
Error Probable Cause Remedy
Water is leaking
from the iron
when the steam
button is pressed.
Thermostat control button ‘.” Or it
can be in the in “..” settings.
Set the thermostat control
button to “…” .
The water level in the water tank
may be above the maximum line.
Empty the excessive
water.
The product may not be on a at
oor.
Place the appliance on a
at ground.
Descale is
formed on the
base.
Too much descale may have
formed in the water tank.
Clean the appliance
using the self-cleaning
function.
Steam does not
exit when the
steam button is
pressed.
Water tank may be empty.
Check the water tank
and ll the water tank
between the MIN and
MAX line level.
The thermostat adjustment button
can be set in the low setting.
Choose a higher setting.
Sounds come
from the water
tank when the
appliance is
operated.
The appliance may not be heated
yet. (sounds are caused by the
expansion of the tank)
This is normal. It will stop
in a few minutes.