fakro ZWP10 - Controller programming - basic functions; Remove Single Device from Movement Buttons (DELETE); Remove Group of Devices from Movement Buttons (DELETE)

11
ZWP 10
1
2
3
1
2
3
x2
x 1
t<1s
4
2
3
I N / E X
2
3
2
3
1
4
x1
1
2
3
4
x2
x 1
t<1s
4
2
3
I N / E X
x 1
2
3
1
1
2
3
4
Choose channel on the controller from which the
device is to be removed.
Within 1 .5 sec. press twice IN/EX button and
once one of buttons of movement of a given
group. LEDs 1 ,2,3 will light up.
Within 1 0 sec. press P button on the device and
hold until LEDs on the controller change into
1 ,2,3.
- Controller signals error by blinking of LEDs 2,3,4
and procedure must be performed again.
Function is used for removing particular device from
buttons of movement without removing it from the
network.
This function is used for removing all devices from
buttons of movement of a given group without removing
them from the network.
Choose channel on the controller from which
group of devices is to be removed.
Within 1 ,5 sec. press twice IN/EX button and
once any button of movement of a given group
until LEDs 1 ,2,3 light up.
Within 1 0 sec. confirm removing devices by
pressing STOP button of a given group.
- LEDs 1 ,2,3 will light up on the controller.
Otherwise procedure must be performed again.
Removing one device from buttons of movement - DELETE
Removing group of devices from buttons of movement - DELETE
Controller programming – basic functions
All manuals and user guides at all-guides.com
all-guides.com