Falcon F2+ - Change Bands

FALCON F  + USER MANUAL
DCI DigiGuide 10.31.2022
DIGITAL CONTROL, INC 41
If you hold the trigger for longer than fi ve seconds, the locator will enter
, which can help with unstable data caused by interference or
extreme depths.
STEP 11 OF 11
Continue Locating as the Drill Head Moves
After the drill head moves forward another rod, fi nd the new RLP, FLP, and
then the LL.
If the new FLP is in line with the prior locate points (a straight
bore line), it is unnecessary to fi nd a new RLP. For a curved drill
path, always identify both the FLP and RLP.
If you have a straight drill path but the FLP is to the left or right
of the line projected from the previous locate points, this may
indicate a drill head de fl ection or interference a ff ecting the
transmitter ’ s signal.
GLOSSARY DEFINITIONS
CHANGE BANDS
STEP 1 OF 4
Stu ff you should know
Switching bands on the transmitter may provide better data, better depth,
and/or better locate results as interference conditions change.
Max
Mode
*