FALCON F
+ USER MANUAL
DCI DigiGuide 10.31.2022
DIGITAL CONTROL, INC 42
Calibrate BOTH bands before drilling so you get accurate depth
readings on both bands.
STEP 2 OF 4
Observe signal strength drop after the drill operator completes a roll
sequence to change bands.
When using a wideband transmitter and the 10-2-7 roll
sequence, transmitter data will disappear after a successful
band change.
STEP 3 OF 4
From the Locate Mode screen, hold toggle right to open the Band Selection
shortcut menu.
STEP 4 OF 4
Toggle to and select the transmitter band without the X in the box (in this
case B
).
To Next Page
Loading...