To Next PageTo Next Page
Need help?Do you have a question about the Falcon F2+ and is the answer not in the manual?
General warnings and precautions for operating the DCI guidance system safely and correctly.
Information on how interference affects system performance and how to manage it.
Steps and importance of registering your DCI equipment for warranty and recovery.
Introduction to methods for selecting optimal frequency bands for jobsite conditions.
Detailed steps for scanning and analyzing noise levels to optimize frequency selection.
Process of pairing selected frequency bands with the transmitter.
Explains when and why calibration is necessary after frequency scans or changes.
Step-by-step guide for performing the upward calibration procedure.
Step-by-step guide for performing the downward calibration procedure.
How to enable and use the Height-Above-Ground feature during drilling.
Detailed steps for locating the transmitter's Rear and Front Locate Points.
How to use Max Mode to stabilize readings in challenging conditions like depth or interference.
Guidance on using the Target Steering feature for accurate drilling alignment.
Step-by-step guide to changing the power mode for V2 transmitters.
Solutions for issues where roll and pitch data is not displayed on the locator.
Steps to verify calibration and identify causes for incorrect depth readings.
General