To Next PageTo Next Page
Need help?Do you have a question about the FALMEC Move Series and is the answer not in the manual?
General| Brand | FALMEC |
|---|---|
| Model | Move Series |
| Category | Ventilation Hood |
| Language | English |
Remove protective film from the sliding panel only after complete assembly.
Measurements for cutting the rear panel of the suspended unit.
Details regarding the alternative rear outlet configuration.
Measurements and diagrams for the installation process.
Steps for drilling, fastening brackets, and inserting the hood into the unit.
Fastening the hood to the unit, centering the motor chamber, and inserting rear brackets.
Installing the check valve, suction pipe, and electrical connection.
Moving the air outlet and installing the check valve.
Optional installation of the carbon-zeolite filter.
Technical safety, aesthetic defects, personal protective equipment, and wall mounting.
Electrical system connection must comply with local standards and be earthed.
Do not connect to combustion fumes pipes; ensure compliance with air discharge standards.
Equipment is for domestic kitchen fume extraction only; other uses are improper.
General warnings for operation, cleaning, and maintenance.
Guidance on minimum distances and considerations for hood placement.
Instructions for hoods with charcoal filters and check valve.
Instructions on when to turn on the hood and select fan speeds.
Guidelines for cleaning internal parts, avoiding liquids and solvents.
Advice on frequent washing and maintenance of metal anti-grease filters.
Instructions for regenerating and replacing carbon and zeolite filters.
