2 ENGLISH
ii
FITTING YOUR MASK
1. Remove all packaging before using your mask.
2. Hold open the bottom straps of the Headgear
with the
Mask Frame
facing downwards.
3. Guide the headgear
over your head so that the silicone
seal
is resting on your forehead.
4. Place your hands on the bottom straps on either side of the
mask frame
and pull out and downwards. Ensure the
silicone seal
rests over your nose and the blue top strap is
sitting on your forehead.
5. Gently tighten the headgear straps of the mask headgear
starting with the blue forehead straps followed by the
bottom straps.
6. The forehead straps should rest horizontally on the forehead,
just above the ears. If required the crown strap can be
adjusted to achieve this.
Useful fitting tips:
• If you are experiencing mask leaks, you may need to lift the
Silicone Seal
o your face and reposition it again.
• Ensure the mask’s headgear straps are not fastened too
tightly.
• The forehead straps should rest horizontally on the
forehead, just above the ears.
iii
DISASSEMBLY FOR CLEANING
1. Unhook the Headgear Clips from the Mask Frame .
2. Slide the forehead straps of the Headgear
downwards
from the top of the Mask Frame
.
3. Remove the Silicone Seal
from the Mask Frame .
4. Remove the Swivel
from the Elbow .
5. Remove the Diuser
from the Elbow .
To Next Page
Loading...
