INTENDED USE
The F&PVitera Full Face mask is intended to be used by adults weighing
≥ 66lbs (30kgs) who have been diagnosed by a physician as requiring
CPAP or Bi-Level therapy. The F&PVitera Full Face mask is intended
for single patient use in the home and for multiple patient use in the
hospital or other clinical setting where proper disinfection of the device
can occur between patient uses.
OPERATING INSTRUCTIONS
• The operating pressure range of your mask is 4 to 30 cmH
2
O.
• The operating temperature range of your mask is 5 to 40 °C
(41 to 104 °F).
• Before using your mask each time, you should:
i. Inspect it for damage or deterioration. If there is any visible
deterioration (cracking, tears, etc.), do not use your mask, and
seek replacement part(s) from your healthcare provider.
ii. Inspect the exhaust holes on the Seal
. Ensure air is flowing
through these holes and do not use if blocked.
iii. Make sure path of air in mask is free from objects that may prevent
breathing.
iv. Ensure Elbow Side Vents
are not blocked.
Note: Please refer to the Warnings and Cautions within this
guide. Failure to follow the operating instructions above may
compromise the performance and safety of the mask.
i
MASK PARTS
Refer to the mask diagram on the inside front cover of this guide.
Seal Forehead Clip
Frame Elbow
Headgear
Swivel
Headgear Clips
Elbow Side Vents
Note: The Elbow is permanently attached to the Frame . It
is not intended to be removed from the mask by the home user.
If removed unintentionally, refer to technical information page for
assembly.
ENGLISH 1
To Next Page
Loading...
