F&P VITERA - Fitting and Assembly Instructions; Mask Maintenance and Cleaning Procedures; Disassembly and Home Cleaning

ii
FITTING YOUR MASK
Remove all packaging before using your mask.
Refer to the fitting images on the inside front cover of this guide.
1. Hold the front of the mask with one hand and the Headgear
with
the other. Ensure that one Headgear Clip
is unhooked from the
Frame .
2. Place the Seal
onto your face and guide the Headgear over
your head.
3. Hook the unattached Headgear Clip
onto the Frame
.
4. Gently tighten the Headgear straps of the Headgear
starting
with the bottom straps, followed by loosely fitting the blue forehead
straps.
Caution
To avoid the risk of suocation, ensure the headgear is not
overtightened. The mask, when fitted correctly, should be able to
be pulled away from the mouth without adjusting the headgear
straps or disconnecting the Headgear Clips
.
Useful Tips:
• If you are experiencing mask leaks, you may need to lift the Seal
o your face and reposition it.
• Ensure the Headgear straps are not fastened too tightly.
• The blue forehead straps should rest horizontally just above the
ears. If required, the crown strap can be adjusted to achieve this.
• For easy mask removal, rotate Headgear Clip
downward to
unhook Headgear .
iii
DISASSEMBLY FOR CLEANING
1. Unhook the Headgear Clips
from the Frame
.
2. Slide the Forehead Clip
downwards towards the Seal .
3. Remove the Seal
from the Frame .
4. Remove the Swivel
from the Elbow .
2 ENGLISH