ASSEMBLE INSTRUCTIONS
The fan is packaged with its foundation and/or other parts unattached. You must attach
them before operating the fan.
WARNING: Never operate without its foundation and/or other parts attached. Do operate
the fan only in upright position; any other position could create a hazardous situation.
Assemble sequence of the foundation and other parts as follow:
a. Unpack the fan and remove all the parts from the package.
b. Use the bend bolt and the press plate provided to attach the stand post assemblies to
the base.
c. Adjust the lift pole to a desired length, and then lock it with the locknut for lifting.
d. Loose the locknut for switch case and insert the lift pole into the hole located on the
bottom of the switch case in place, then fasten the locknut back tightly.
To Next Page
Loading...