a. Press the button on to start the fan and select the fan speed level, as per the following
sequence: 1 2 3 1
The fan speed selecting can be circulated and the speed pilot lamp will be on during the fan
operating.
b. Press the button Mode to choose your desired wind mode as per the following sequence:
normal wind nature wind sleeping wind normal wind
The wind mode selecting can be circulated and the wind mode pilot lamp will be on during
the fan operating.
c. Set the time by pressing the timer button to select a desired timing level, the range is
between 1-15 hours. The pilot light corresponding to the selected timing level will be
illuminated.
d. Press the shaking head knob to select whether you need to let it shake head, as per the
following sequence: shaking not shaking shaking
Press the button OFF To turn off the fan, and all the pilot lights will be go out.
Note: all above functions can be operated under the remote control.
User Servicing Instructions：
——how to physically replace the fuse：
WARNING：If the FUSE is broken, do not try to replace it yourself, it must be
replaced by the manufacturer or its service agent to avoid a hazard, or find your
dealer direct to replace a new product.
a) Grasp plug and remove from the receptacle or other outlet device. Do not unplug by
pulling on cord.
b) Open fuse cover, slide open fuse access cover on top of attachment plug towards blades,
or push on tabs located next to the blades.
c) Remove fuse carefully, such as whether to push the fuse from the other side or turn fuse
To Next Page
Loading...