EasyManua.ls Logo

fanttik EVO300 - Frequently Asked Questions (FAQ)

fanttik EVO300
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8. SPECIFICATIONS
9. FAQ
Model
Capacity
USB-C-1
USB-C-2
USB-1
USB-2
Battery
Frequency
Solar Charger
Weight
EVO300
83,200mAh/299Wh
PD60W
5V/3A
5V/2.4A
QC 3.0 18W
Lithium-ion
60Hz
MPPT 12-30V
10.9 lbs
A: T300 power stations have a built-in MPPT controller.
Note: Storage instruction: fully charged every 3 months for best results and store it between -20 and 45 °C. Keep your portable power station away from heat and
direct sunlight in order to extend its life span.
Q5: Can it charge and discharge simultaneously?
Yes, but it is not recommended to charge and discharge at the same time in order to preserve battery lifespan.
Q6: How to extend the using time of CPAP?
Recommend to turn off its humidifier, heater, and set a lower pressure.
Q7: Can the AC output carry a refrigerator or air conditioner?
Workable for low power, and over 100W is not recommended. The starting power of refrigerators and air conditioners is generally 5~7 times higher than the rated
power, which easily triggers AC overload.
Q8: Can two power stations be used in parallel?
No.
If the product cannot charge or power other devices, please checking according to the following steps:
1.
2.
3.
4.
Q1: What devices can EVO300 power?
A: Please note that the AC output port can only charge/power devices that operate at less than total 300 Watt.
Q2: Can the EVO300 be charged while using?
A: Yes, EVO300 supports pass-through charging. But we don't suggest, it will cause damage to battery
life.
Q3: How to know the working times for my device? Why does the duration of some devices deviate from the actual usage data?
A: Working time = 299Wh* 0.85/operating wattage of your device. The duration of our equipment is based on laboratory data, and the duration of specific
equipment usage may vary.
Q4: Does EVO300 include a built-in MPPT controller?
- 09 -