EasyManua.ls Logo

FAR K109 - Defrosting;First Use and Installation; Description of the Product

FAR K109
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISHENGLISH
GB-13GB-12
(1) Calculation on the basis of results for 24
hours under standard test conditions. e
actual energy consumption will depend on
use and the location of the device.
Never touch the interior of the freezer chamber
or frozen foods in the compartment with wet
hands as this could result in frostbite.
e above image is for reference only;
Conguration is subject to the actual product.
DESCRIPTION OF THE PRODUCT
Door Knob
Door
Hinge
Basket
Side cover
Power
Foot
Drain
Power supply
cord with plug
Temperature
control knob
You should defrost the freezer compartment two
or three times a year when the ice is about 4mm
thick. To defrost, follow these steps:
-Set the thermostat to “Colder” at least 12 hours
before defrosting.
After this period has elapsed, switch o the
freezer compartment by removing the plug
from the main power supply.
Remove all food from the freezer and wrap
them in paper and store them in a cold place
and leave the door open.
When the defrosting is nished, the
compartment must be cleaned and wiped dry.
Switch the appliance back on using the
thermostat set to “Colder and, wait at least
one hour before replacing the foodstus.
After a few hours the thermostat can be set
back to the original position.
WARNING:
Do not use mechanicals devices or other
articial means to accelerate the defrosting
process, other than those recommended by the
manufacturer.
DEFROSTING/FIRST USE AND INSTALLATION