GB-41GB-40
NOTE: When following this procedure from
step1 to step 2, the lter system will be removed;
when following it from Step 2 to Step 1, the
lter system will be installed.
Remarks:
• Inspect the lters for blocking after every time
the dishwasher has been used.
• By unscrewing the coarse lter, you can
remove the lter system. Remove any food
remnants and clean the lters under running
water.
NOTE: e entire lter assembly should be
cleaned once a week.
Cleaning the Filter
To clean the coarse lter and the ne lter, use
a cleaning brush. Reassemble the lter parts
as shown in the gures on the last page and
reinsert the entire assembly in the dishwasher,
positioning it in its seat and pressing downwards.
WARNING!
When cleaning the lters, don’t knock on them.
Otherwise, the lters could be contorted and
the performance of the dishwasher could be
decreased.
Caring for the Dishwasher
Opene control panel can be cleaned by using a
lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish
wax.
Never use sharp objects, scouring pads or harsh
cleaners on any part of the dishwasher.
Cleaning the Door
To clean the edge around the door,
you should use only a soft warm,
damp cloth.
To avoid penetration of water into the door lock
and electrical components, do not use a spray
cleaner of any kind.
WARNING!
• Never use a spray cleaner to clean the door
panel as it may damage the door lock and
electrical components.
• Abrasive agents or some paper towels should
not be used because of the risk of scratching or
leaving spots on the stainless steel surface.
To Next Page
Loading...
Need help?
General
