FAR LV13C46S22W - User Manual

Questions and Answers

D
dedwardsAug 19, 2025
How to prevent food residue on dishes in FAR LV13C46S22W Dishwasher?
- G
  garrettedwardAug 19, 2025
  If food residue remains on dishes after a wash cycle in your FAR Dishwasher, ensure you've selected the appropriate program for the dirt level and type of tableware. Use the recommended detergent in the correct amount. Check that the water inlet pressure is within the range of 0.03-1MPa. Inspect the spray arm for any blockages and clean it if necessary. Also, make sure you are loading the tableware properly, ensuring it doesn't obstruct the spray arm's rotation or interfere with the dispenser. Finally, check and clean the filter if it's blocked.
J
James BarnesAug 21, 2025
Why my FAR LV13C46S22W Dishwasher does not work?
- J
  Joshua BruceAug 21, 2025
  If your FAR Dishwasher isn't starting, several things could be the cause. First, make sure you have pressed the start button. Check that the door is fully closed and locked. Verify that the power supply or power cord is correctly connected. Also, inspect the fuse or circuit breaker and replace or reset if necessary. Finally, ensure the child lock is disabled, as this can prevent the dishwasher from starting.
H
hamiltonlauraAug 23, 2025
How to get rid of odor in FAR LV13C46S22W Dishwasher?
- M
  Michelle LopezAug 23, 2025
  If your FAR Dishwasher smells, it could be due to a few reasons. If a program was stopped prematurely, leaving residual water, ensure the dishwasher is empty, power it on, select the program cancellation option to remove the water, and then run the 'Intensive' program with detergent. Food at the bottom of the dishwasher or in the filter can also cause odors; clean these areas according to the 'Maintenance' section. If unwashed dishes have been sitting for a while, place a cup of white vinegar in a glass or bowl on the upper rack, but be mindful that frequent vinegar use may damage the appliance.
J
Jennifer BellAug 26, 2025
Why are there spots on dishes after washing in FAR Dishwasher?
- N
  Nichole YoungAug 26, 2025
  If you notice spots on your dishes after using the FAR Dishwasher, avoid overloading it and ensure proper placement of tableware, referring to the 'Operation Instruction' section for guidance. Also, check that the water pressure is adequate, maintaining a pressure between 0.03-1.0 MPa, and use the recommended amount of detergent, consulting the 'Operation Instruction' section.
G
Gregory WilliamsAug 28, 2025
Why is my FAR LV13C46S22W Dishwasher so noisy?
- B
  brianawalkerAug 28, 2025
  Some noise during the operation of the FAR Dishwasher is normal. The drainage pump will make noise when draining. If the dishwasher is excessively noisy, check if it is leveled and adjust the feet if necessary. Also, ensure that the spray arm isn't hitting the dishes, and re-adjust the arrangement if needed.
E
Elizabeth SolisAug 30, 2025
What to do if FAR LV13C46S22W Dishwasher leaks water from the front?
- L
  Lauren SmithAug 30, 2025
  If your FAR Dishwasher is leaking water at the front, first check that the machine is properly leveled from side to side and front to back, referring to the leveling instructions in the 'Installation' section. Also, ensure you are using the correct detergent. If excessive foaming is causing the leak, allow the foam to dissipate for 24 hours, and then clean the interior with milk.
A
Alicia JacksonSep 1, 2025
Why is there turbidity on glassware from FAR LV13C46S22W Dishwasher?
- D
  Diana WarrenSep 1, 2025
  If your glassware appears turbid after being washed in the FAR Dishwasher, it could be due to using too much detergent with hard water. Try using less detergent and rinse aid.
E
epattonSep 3, 2025
Why are dishes not drying in FAR Dishwasher?
- P
  Patricia BrownSep 3, 2025
  If the dishes are not drying in your FAR Dishwasher, check the dispenser and refill it if it is empty.
J
Justin AllenSep 5, 2025
What to do if water remains in my FAR LV13C46S22W Dishwasher after washing?
- V
  villegasaaronSep 5, 2025
  If water remains on the machine liner of your FAR Dishwasher after washing, the drain hose may be kinked or blocked. Adjust the hose to remove any kinks or remove the blockage.
D
Daniel HowardSep 7, 2025
How to remove black marks from dishes in FAR Dishwasher?
- R
  ruizmauriceSep 7, 2025
  If you notice black or gray marks on dishes washed in your FAR Dishwasher, it's likely that aluminum products are rubbing against the dishes during the wash cycle. Re-adjust the arrangement of the dishes to prevent this contact.