ERROR CODE
Fault Possible reason Soluon
E1 Problems in water inlet.
-Check whether the water inlet
hose is blocked, knoed or frozen.
-Check the water supply.
-Check whether the drain hose is
blocked,knoed or frozen.
Drainage problems.E2
-Clean the air gap or dispose of it.
The air gap is blocked.
The filter is blocked. -Clean the filter.
E3 Abnormal heang alarm. -Please unplug and seek aer-
sales service.
E4 Water leakage. -Turn off the water supply of the
dishwasher and seek aer-sales
service.
-The dishwasher stops running,
an alarm sounds and the drain
pump works intermiently.
E6 Communicaon circuit failure. -Please unplug and seek aer-
sales service.
E7 Excessive water supply failure. -Please unplug and seek aer-
sales service.
E5 Heater circuit failure. -Please unplug and seek aer-
sales service.
E9 Shout value failure. -Please unplug and seek aer-
sales service.
E11 Low power alarm. -Please unplug and seek aer-
sales service.
E12 High power alarm. -Please unplug and seek aer-
sales service.
GB-45