GB-49GB-48
How to Drain Excess Water from Hoses
If the sink is 1000 higher from the oor, the
excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain
excess water from hoses into a bowl or suitable
container that is held outside and lower than the
sink.
Water Outlet
Connect the water drain hose. e drain hose
must be correctly tted to avoid water leaks.
Ensure that the water drain hose is not kinked or
squashed.
Extension Hose
If you need a drain hose extension, make sure to
use a similar drain hose.
It must be no longer than 4 metres; otherwise
the cleaning eect of the dishwasher could be
reduced.
Syphon Connection
e waste connection must be at a height less
than 1000 mm (maximum) from the bottom of
the dish.
e water drain hose should be xed.
Start of Dishwasher
e following things should be checked before
starting the dishwasher.
e dishwasher is level and xed properly
1. e inlet valve is open
2. Fill hose connections are fully tightened and
not leaking
3. e wires are tightly connected
4. e power is switched on
5. e inlet and drain hoses are knotted
6. All packing materials and printings should
be taken out from the dishwasher
Attention: After installation, please make sure
to keep this manual.
e content of this manual is very helpful to the
users.
To Next Page
Loading...
Need help?
General
